Tree Cutting Notches
Cutting down a mature tree isn’t as easy as just stroking away at it with an axe. There are particular techniques that need to be followed to preserve the wood and ensure the safety of the people cutting down the tree. To know how a tree will fall, the cutter will need to determine the right kind of cut to use.
Before you begin to study the correct tree trimming method, you need to make sure you have the right tools for the job. The equipment you use should be of good quality and must be tested before utilizing it on a tree. The following list covers the main pieces of equipment that would be needed to cut down a mature tree on your property.
Chain Saw: This is an essential piece of equipment that will be needed. The cutting apparatus should have around 3.5 horsepower and a 20-inch bar. The bar length demonstrates the blade that the cutting edge can infiltrate, so 20 inches should be sufficient to cut down most trees.
Safety Glasses: Many individuals neglect the significance of utilizing safety glasses while doing work like this. Nonetheless, flying debris can genuinely hurt your eyes when cutting with a cutting apparatus.
Leg Protection: In the event you hit a bunch in the tree, the saw can possibly kick out of the tree and hit you in the leg. It is suggested that you use either knee-high safety boots or wear heavy leg defenders.
Test Rope: The rope should be about three times longer than the tree’s height. It will be used as a safety backup in case there are any problems.
There are 3 main notch types that individuals can use during tree cutting.
The open-faced notch
The open-faced notch is perfect for trees that require a high level of accuracy. On the off chance that the individual is cutting in a tight spot, where accuracy is pertinent, the open-faced notch is considered the safest and secure notch to use. In this notch, a vast, sideways V is cut into the side of the tree. The primary cut goes in a downwards movement of no less than 70 degrees. The base cut goes in at a 20-degree upward edge. At that point, a little flat cut will be made on the back of the tree, meeting the point in the V. The main drawback to this step, other than the extra time needed, is that the cutter will need to remove the hinge, in which there will be a less amount of wood lost.
The Conventional Notch
The Conventional Notch is named is much like it’s name since it is the most well-known kind of notch used. It is the favored technique among loggers and tree evacuation specialists because it’s safe and fast at the same time. Despite everything it permits a specific amount of accuracy, however not as much as the open-faced notch. In this notch, the topmost cut goes in at an angle, while the bottom cut is horizontal.
The Humboldt Notch
The Humboldt notch is another common notch when cutting trees. In this notch, the top cut is made horizontally, while the base goes in at an upward point. In this type of notch, the kickback over the stump may be bigger, so it is not perfect for inclining trees. However, this notch saves a considerable measure of wood, so when the tree is being cut with the purpose of using the wood, then the Humboldt notch is a decent decision to make.
In the event a tree is leaning in a way that it can’t be allowed to fall, non-experts should always consult with a tree removal service to make sure the tree cutting is carried out as safely as possible.